联系我们

常熟志凯地坪工程有限公司

联系人:常经理

手  机:15021510994

   131-5165-7583

地  址:常熟市枫林路27号


新闻中心

网站首页 > 行业问题 > 导致环氧地坪漆表面粗糙的因素有哪些?在施工过...

导致环氧地坪漆表面粗糙的因素有哪些?在施工过程中又该如何预防呢?

发布日期:2020-04-05 内容来源于:http://www.hbxmzq.com/

更多 0

环氧地坪漆采用一次性涂覆工艺,不管有多大的面积,都不存在连接缝,而且表面光滑平整、附着力强,耐摩抗压,装饰性效果非常好。但是有的客户做完无锡环氧地坪漆之后却是表面比较粗糙,非常影响美观性,这是什么原因造成的?在施工过程中又该如何预防呢?:导致环氧地坪漆表面粗糙的因素


Epoxy floor paint uses one-off coating process, no matter how large the area, there is no joint, and the surface is smooth, smooth, strong adhesion, friction and compression resistance, decorative effect is very good. But some customers finish the epoxy floor paint, but the surface is rough, very affecting the aesthetics, what is the reason for this? How to prevent in the construction process? The factors leading to rough surface of epoxy floor paint are as follows:


5、一次配料过多。环氧地坪漆是双组份材料,以当涂料混入固化剂后,涂料就开始起化常熟环氧地坪学作用,环氧地坪漆涂料黏度就慢慢升高,到特定时间后就开始胶化,直接最后固化成膜。当涂料开始胶化仍继续施工时,地坪漆涂膜就可能出现粗糙了。


5. Too many ingredients at one time. Epoxy floor paint is a two-component material. When the paint is mixed with curing agent, the paint begins to play a chemical role. The viscosity of the epoxy floor paint increases slowly. After a certain time, it begins to gel and solidifies directly into film. When the coating begins to gelatinize and continues to be applied, the film of floor paint may be rough.


6、施工现场温度太高,稀释剂挥发太快,环氧地坪漆施工后没有流平的时间就已经开始固化,也会常熟环氧地坪导致环氧地坪漆表面粗糙。


6. The temperature of the construction site is too high, the diluent volatilizes too fast, and the epoxy floor paint solidifies without leveling time after construction, which will also lead to the rough surface of the epoxy floor paint.

微信图片_20200307175207.jpg

1、环氧地坪漆材料使用前没有进行过滤,含有杂质,这些杂质在环氧地常熟环氧地坪坪漆施工时粘在涂膜表面,最后就会造成环氧地坪漆表面粗糙。


1. The epoxy floor paint material is not filtered before use and contains impurities. These impurities stick to the surface of the film during the construction of the epoxy floor paint, which will eventually result in the rough surface of the epoxy floor paint.


2、环氧地坪漆施工之前没有将地面打磨平整、杂物清除干净,也会造成环氧环氧地坪漆施工后表面粗糙。


2. The surface of epoxy floor paint will be rough if it is not ground and cleaned up before construction.


4、环氧地坪漆施工现场灰尘比较多,特别是在面漆施工过程中没有进行现场封闭,导致灰尘落在还处于流平阶段的漆膜上,最终导致灰尘黏附于地坪漆涂膜上而使涂膜出现粗糙现象。


4. There is a lot of dust in the construction site of epoxy floor paint, especially in the process of surface paint construction, which causes dust to fall on the film which is still in the leveling stage, and eventually causes dust to adhere to the floor paint film and make the film rough.


3、环氧环氧地坪漆中涂砂浆层和腻子层施工后没有进行打磨处理,也会造成环氧地坪漆表面粗糙。


3. The surface of epoxy floor paint will be rough if the mortar layer and putty layer are not polished after construction.


相关标签: 常熟环氧地坪

相关产品:
相关评论:
暂无评论
在线评论:
评论人:
联系方式:
评论内容:
验证码:  换一张